11/13/2023 0 Comments Freud router bit setGranted, I am a novice sign maker, but I’ve used a router enough to know good bits when I use them. There were no chunks taken out of the letters, no blow outs on the side of the boards, no damage to patch. When I was finished routing the letters, the grooves were so clean that all I had to do was run sandpaper lightly over the edges to clean them up. I turned the board over a few times to dump the sawdust out of my project, which took much less time to make than I anticipated. These bits made clean, quick work of my sign. After testing each bit, I picked the two that I liked the best for the look of the sign I was making and went to town. With all of the bits, the edges were at worst minimally frayed in a few spots. As with all router bits, start by making shallow passes and slowly work your way up to a deep groove. I wrote in both print and in cursive to see how easily they cut through the pine board’s grain pattern from all angles. You could also use these bits in wood composites, plastics, or aluminum. I tested these bits one-by-one by routing letters into pine. The 90 degree V-Groove bit has 1/2” shank, so be aware that if your router doesn’t accept 1/2” shanks this bit will be useless to you. With the exception of one of the V-Groove bits, all of the bits have 1/4” shank. If you were to carelessly try to pull one out of the base using the business end of the bit, you WILL slice your finger. A word of warning-these bits are incredibly sharp. I do not own a CNC machine, so I tested these bits using my RYOBI Cordless Trim Router Review – P601. The case is a nice touch, as it will keep the bits protected and sharp. Each bit sits snuggly into the base, which is covered by a clear plastic case. The packaging of these bits is fantastic. Testing The 8 Piece CNC Freud Router Bit Signmaking Set
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |